PA Input Protection - Pass Pulsed RF and block CW
I have a pair of 1600W amps that we want to put together in a chassis as a balanced pair for high RF power testing. The amps can only handle pulsed RF input signal up to 10% duty cycle.
I am looking to see if anyone has done anything like this before. Mostly to see if there are any "COTS" type options.
I think I could get there with a direction coupler in line and a log detector on the coupled port. Then use and FTDI Minimodule with logic setup to monitor a log amp output and have it control an RF relay on the input that would either pass the pulsed RF or dump the CW into a load.
Sign in or register to add a comment.
Add a Comment
About Our Site
Biological Effects and Applications
Computer Aided Design
Emerging Applications and Technology
Filters and Passives
MMIC and RFIC
Packaging and Materials
Sources and Receivers
Test and Measurement
Steps for connecting Femal-to-Female adaptor into a male connector in the RF measurement equipment
About the additional metal plate for RF PCB (Ku band)
RF Rectifier Simulation in ADS
Beyond Maximum Stable Gain of an RF Transistor
Terms of Service
Useful Hints and Tips
Created with PlushForums
© 2024 Microwaves 101 Discussion Board