• Norman grody
    0
    I just began to experiment with a low power (5 dB m) continuous and pulsed radar. I am hoping to use the radar to measure the radar cross section (RCS) of different materials. This experiment is intended to compare the RCS with surface emissivity measurements obtained radiometrically. However, I observed wave interference in the measurements similar to the case of a slotted line that I am trying to eliminate. I tried using separate antennas spaced apart as well a single antenna using a circulator for separation and got the same interference pattern. Any suggestions or explanations would be appreciated.
  • madengr
    1
    Use a VNA in time domain mode to gate out the reflections.
  • Norman grody
    0
    Thanks, I agree with you. I was just hoping to avoid the need for digital processing in the time domain.
bold
italic
underline
strike
code
quote
ulist
image
url
mention
reveal
youtube
tweet
Add a Comment

Welcome!

Join the international conversation on a broad range of microwave and RF topics. Learn about the latest developments in our industry, post questions for your peers to answer, and weigh in with some answers if you can!