Working out the dimensions of an 'end launch' waveguide to coax transition
1st post for me so thank you for making this great site, it has been a wonderful resource for me.
I'm a bit of an RF noob so if I say/ask something that doesn't make sense, please explain why.
I was wondering how to properly dimension an 'end launch' WG to coax transition (also, am I correct in assuming this is what I want for TE10 mode?). I can find plenty of resources for the other option (right angle) but I've spent a few hours and a few days searching for detailed info on this subject. I've looked at the two references on the relevant microwaves101 page but the few pages google shows me in those books doesn't talk about it specifically and I wanted to know for sure if there was a good resource I can use to study up.
Any help would be appreciated here. Thanks. Otherwise it's off to the university library for me.
My advice is to buy a used one, hack it open and try to scale the dimensions to the band of interest. Then use HFSS to check performance....
Sign in or register to add a comment.
Add a Comment
About Our Site
Biological Effects and Applications
Computer Aided Design
Emerging Applications and Technology
Filters and Passives
MMIC and RFIC
Packaging and Materials
Sources and Receivers
Test and Measurement
Heating problem Waveguide WR 1800 to Coaxial Adapter
Coax Loss Calculation and Phase
Storing expensive coax adapters?
Connector for waveguide transition
Terms of Service
Useful Hints and Tips
Created with PlushForums
© 2023 Microwaves 101 Discussion Board