I have made a capacitor on a teflon substrate which is just two 10 cm long parallel copper tracks with 5 mm spacing between them. When I connect Radiofrequency (<200 MHz) source to it , the electrical field is not uniform along the length of the capacitor. How could i make this field uniform?
Just curious, how do you know the field is non-uniform? is this a series cap or a shunt cap?
10cm is ~7% of a wavelength, 24 electrical degrees, I think there should not be much of a distributed effect. but you could try two 5cm line/pairs in parallel.... or five 2.5cm lines that have four uniform gaps...
Sign in or register to add a comment.
Add a Comment
About Our Site
Biological Effects and Applications
Computer Aided Design
Emerging Applications and Technology
Filters and Passives
MMIC and RFIC
Packaging and Materials
Sources and Receivers
Test and Measurement
Coplanar Waveguide Marchand Balun
Balun combined amplifiers
waveguide cut-off and the attenuation below that
Connector for waveguide transition
Terms of Service
Useful Hints and Tips
Created with PlushForums
© 2022 Microwaves 101 Discussion Board