Wilkinson resistor test
We've all used Wilkinson power dividers... the network shorts out the resistor. So how do you know the resistor value is within specified tolerance? OK, maybe the tolerance could be +/-10%, so it would be hard to screw up a thin-film job. Or maybe you are attaching 0402 (or even 0201) resistors to a circuit card. How would you know if one shorted out, or became an open. Or during a high-power odd-mode event, you might want to know if you blew the resistor without opening up the box.
Here's an idea, but I am not smart enough to know if it is practical... what if you added some type of electrical loop through the Wilkinson, and tried to measure the "Q" of the network by coupling AC power to it. A resistor would behave differently than a short or an open, right? Seem like a job for an antenna engineer.
Thanks for your thoughts, even if you tell me it is a stupid idea (but explain why).
I assume you are trying to do this in-situ without access to any of the ports?
I was messing around several months ago with non-destructively measuring dielectric constants of curved plastic radomes. You can cut a piece of 1/2 wavelength copper tape and lay it on the plastic, then take two small coax loop probes and magnetically couple near the center of the dipole, looking at Q and resonant frequency. It easily tells the difference between ABS and anti-static plastics.
Maybe you can couple to the output traces, as the isolation will degrade with the resistor open or shorted.
Geez, we just printed identical resistors to nowhere adjacent to the "real" resistors and measured those. Did this for space products. The ohms per square of the resistor material is set and stabilized with a high temperature bake. The alternate resistors verify the process.
Sign in or register to add a comment.
Add a Comment
About Our Site
Biological Effects and Applications
Computer Aided Design
Emerging Applications and Technology
Filters and Passives
MMIC and RFIC
Packaging and Materials
Sources and Receivers
Test and Measurement
Thick film resistor materials
Modified Wilkinson HFSS
N stage wilkinson
Max. Power dissipation per unit area of thin film materials
Terms of Service
Useful Hints and Tips
Created with PlushForums
© 2021 Microwaves 101 Discussion Board