That is a great question! I took a look around, some designs just show a three-port box with labels...

Maybe a picture like this?

https://en.wikipedia.org/wiki/Orthomode_transducer#/media/File:Orthomode-transducer_01.jpg

Sorry I am not a huge help, I'll try to ask an antenna person.

Steve

Thanks

there will likely be some routing between the combiner and the amplifiers, so I consider the phase angle of the failure unknown, and possibly a strong function of frequency. The failure could be a short circuit somewhere back inside the amplifier, or a blown wirebond, or almost anything. For sure, adding the isolation resistor will help the remaining amplifiers see a decent match, with the caveat that the resistor does not blow up...

I will take a look at the reflection coefficients that are seen by constituent amplifiers in a combiner, when the amplifiers have random phase and amplitude errors, and see what that tells me..

Not sure I understand where this comes from

Z= Zo x sqrt(mu_r/epsilon_r)

But I'll try to give it some more thought!

Thanks
Steve

Thanks! Someone should be getting in touch...

You know, I have been looking for an excuse to visit them... I'll try to get over there and ask. Need to be sensitive about anything proprietary of course. Thanks for asking!

Thanks! That is a very active message board, I will peruse it. But I don't want to take on a project like this, it might end up in forgotten pieces as my attention span is pretty short these days. I wonder if Shariar at Signal Path (on Youtube) would do contract work or knows someone that does...

Steve

Thanks, I will add a link to that info. I know who to call when I need help on de-embedding!

Great news on the scikit-RF shirt my old one is in tatters and stained from doing an oil change. Will order a new one.

Steve

Is this for waveguide?

Turns out MSE Supplies in Tucson can thin SiC wafers if anyone else is interested

Thanks

My friend
You have pointed out the weak part of Wilkinsons in SSPAs.... the resistor is going to blow up!
Steve

Still have yet to find a source for this...

Steve

All of the pages on Microwaves101 on PIM were contributed by Jack Kouzoujian, maybe 20 years ago. He was (is?) the head of Matrix Test Equipment. If you can find him, he could be a lot of help.

http://www.matrixtest.com/


Steve

isn't this something you can buy from MilliBox? I am by no means an antenna guy...

https://millibox.org/anechoic-chamber/

Steve

At some point I would like to capture the ipedance formula that takes into account mu... let me know where there is a good explanation of that.

The microwave office TXLine calculator does show some effect on Z0 when resistance increased, but not enough to explain a 10% shift.

Steve

It is a very hard material to grind.... that is why they make sandpaper out of it! someone told me about a shop that can hopefully do this::

https://arcnano.com/

Thanks again
Steve

WIN semi would also be my guess. I wonder how many other fabless companies use them...

Thanks!

There might be some type of header that fits over the drain supply pin, but that would not work on the ground lug. Honestly, I like your idea, especially since you never have to worry about a clip-leab falling off!

Steve

It does seem weird that there are 2.92 to 3.5mm adapters available... how accurate do you need a calibration? if you don't work for NIST maybe you can ignore a slight discontinuity.

I would like to see the data sheet on the 2.92 mm connector with dielectric.... Thanks!

Keep in touch!
Steve

I'm not sure I have this, but I'll look at some old MWO files. If you have the calculation in Excel or just equations can you provide them?

Steve

I finally got around to adding this info to the interpolation page... Thanks again!

https://www.microwaves101.com/encyclopedias/s-parameter-interpolator